So, without further ado, here is a tutorial for 'newbies'. Enter the Administrator account User Name and Password. Glarysoft Registry Repair is an advanced. Also use interlocked bit operations since they are faster. Thank God for Copy and Paste.ĪPC FIX REGISTRY v.2007 2008.22432 - Creation of paging file fixed, and failure to create it is no longer a blocker for the boot process just try to run without paging file. Bug reports should be targeted against the 8.īug reports should be targeted against the 8. Typically, these upgrades do not require the device the Network Management Card is installed in to be powered down or cause unnecessary downtime. The runtime estimate while it is fully charged and on power under this load (per powerchute software) says about 19-20 minutes as well.Īll the batteries seem to check out fine for voltage levels without load when tested individually when they claim they are fully charged - but I think my issue might be having one or two be bad, but I have no idea how to figure out which one('s) it might be.To install the application module, repeat step 5 and step 6. APC's runtime chart really claims that should be closer to 25min, and doing the math myself (7.8a on 5ah) tells me it should be about ~19-20min. Putting a 700w (~7.8a) load on it gets me between 7min40sec and 8min flat. Powerchute runtime calibration doesn't do anything either. Tried disconnecting the battery pack and deadheading the unit by leaving it unplugged with the power button pushed for 12hr, no change either. I've tried dealing with the apcfix.exe tool to reset battery constants and checking it myself, but that doesn't seem to be the issue. It takes several hours to charge back up to 100% from there as well (based on the software) The main issue I seem to be seeing is that the second it goes under battery power (even without a load present, or when it was just my raspberry pi) is that the battery charge level immediately drops to 60% within 3-4 seconds. Hey guys - I've got an APC SUA2200RM2U I picked up a few weeks ago, and I picked up a set of 8 new 12v 5ah batteries (UB1250) (which seemed like the main replacement type that everyone was listing/selling everywhere) - but my runtime is terrible (actual, not estimated) compared to my expectations from math or from APC's runtime chart.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |